Oky Newstar Technology Co., Ltd
Starter Kits,Controller Board, Sensor Modules Factory DIY Educational programmable Robot Projects manufacturer
Add to Cart
Mini Nano V3.0 ATmega328P 5V 16M Micro Controller Board Module
Product Description:
1. The Pro Micro is similar to the Pro mini except with a ATmega32U4 on board. The USB transceiver inside the 32U4 allows us to add USB connectivity on board and do away with bulky external USB interface.
2. This tiny little board does all of the neat-o Controller board tricks that you're familiar with: 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Running at 16MHz and 5V, this board will remind you a lot of your other favorite Controller board-compatible boards but this little guy can go just about anywhere. If you're supplying unregulated power to the board, be sure to connect to the "RAW" pin on not VCC.
Product features:
Running at 5V/16MHz
Supported by Controller board IDE v1.0.1
On-Board Micro-USB connector for programming
4 x 10-bit ADC pins, 12 x Digital I/Os
Rx and Tx Hardware Serial Connections The Pro Micro is based on the ATmega32U4 microcontroller,it running at 5V/16MHz
Supported by Controller board IDE v1.0.1
There are 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections RX and TX on Pro Micro
The ATmega32U4 chip on the Pro Micro board comes preprogrammed with a bootloader that allows you to upload new code to it without the use of an external hardware programmer
The PRO Micro board can be powered via the micro USB connection or with an external power supply
Specification:
| Controller | CH340G |
| Input Voltage (recommended) | 7-12V |
| Digital IO pins | 14 (of which 6 provide PWM output) |
| DC Current per I/O Pin | 40 mA |
| SRAM | 2 KB |
| Clock Speed | 16 MHz |
| Operating voltage(logic level) | 5V |
| Board Weight | 5g |
Product Photos
